Technical Support
The error codes displayed on the controller make it easy to diagnose the problem with the TV Lift. Search for the correct error from the list. Follow the instructions, if the problem can be solved by yourself we will give you all the necessary steps. For more complicated faults please contact our technical support department.
Assigning RF remote to control box
Wciśnij dowolny przycisk na pilocie aby przypisać lub poczekaj 15 sekund by wyjść z trybu
AUTOLID Limit switch cable harness disconnected
Check all the connections and contacts from AUTOLID to the control box. Some pins might be loose due to transport of furniture fitting
Safety system activated
Remove obstacles from the lift's way. Eventually, reduce the safety system sensitivity
LIFT Limit switch cable harness disconnected
Check all the connections and contacts from the Lift to the control box. Some pins might be loose due to transport of furniture fitting
Attempt on setting DOWN VP position before the DOWN limit switch
Use this option only intentionally. It is not recommended to set DOWN VP higher than where the limit switch is located
LIFTs wiring disconnected
Lift electric motor overload
Lower the LIFTs load
AUTOLIDs wiring disconnected
Check all the connections and contacts from AUTOLID wiring to the control box. Some pins might be loose due to transport of furniture fitting
AUTOLID electric motor overload
Lower the Autolid load (lid too heavy)
Rotating movement stopped due to safety
Remove obstacles from the lifts way
No impulses from LIFTs Motor
The LIFT motor might be blocked mechanically, unable to start moving. The cables might be loose. Many reasons for this error – please contact Sabaj support, providing photos of the installation
UP VP Memory approved
Furthest left rotation acquired (mechanical stop)
No impulses from LIDs Motor (Rotolift + Autolid only)
The LID motor might be blocked mechanically, unable to start moving. The cables might be loose. Many reasons for this error – please contact Sabaj support, providing photos of the installation
Left (M1) rotation angle approved
Furthest left rotation acquired (mechanical stop)
Full motion reset
Attempt on setting UP VP lower than DOWN VP
Re-set the UP/DOWN settings. This might make the lift unable to move up or down